Label and Heat Shrink Printers

Heat Guns

For direct burial of heavy duty electrical cable, where environmental protection is necessary. Tubing is supplied with an adhesive layer, adding a water tight seal to the strain relief the tubing provides. When exposed to heat (usually a bit lower than the activation temperature of the heat shrink), the inner layer begins to flow (just like a hot melt glue). When the tubing shrinks and cools down, the inner layer forms an adhesion layer between the tubing and the component or wire. This provides a watertight seal, protecting the connector and/or wire in direct burial and submersed applications

Features:

• 3:1 Shrink Ratio with melt adhesive inner lining (shrinks to 1/3 its original diameter)
• Longitudinal Shrinkage: up to 10%
• Meets requirements of AMS-DTL-23053/15 (formerly MIL-I-23053/15), Class 2
• UL 224 VW-1 flame retardant (jacket only)
• Maximum Continuous use temperature 110°C
• Shrink Temperature of 120°C and operating temperature of -55°C to + 110°C
• Crosses to: Canusa CFM, 3M IMCSN, 3M MDT, Tyco Raychem RMW, LG PMWT
• Typical applications include: Electrical insulation - Ideal for exposed or underground applications providing good insulation, waterproofing and mechanical protection. Also suitable for Mechanical and abrasion protection, Physical/Electrical Protection of Components, Strain Relief, and Solder Insulation.

Medium Wall Adhesive Lined Heat Shrink Tubing - Ordering Information

Color available: Black

*Also available in precut pieces. Please inquire.

For $35 extra you can get our economy model heat gun. It has two air speeds, and a temperature control dial for temperatures ranging from 250° to 1100°F

$35

Other Items

Heat Guns

VT-1100 with 2 Air Speeds, and a temp. control dial for range of 250°F - 1100°F

Micro-Therm MJ-600 - Pocket sized cordless refillable butane heat source. Great alternative to electric heat guns. Waterproof piezo electronic ignition, safety lock trigger, and a reflector shield for use with heat shrink.